You recieved the 2 RA pump fittings as a bonus, It just makes your routing options easier since your kit got shipped out late due to a oversight. The
check valve simply slips into the hose. Use a little bit of WD-40 on the tips and slip it right in. Trust me you'll never be able to pull it back out.
You have 2 tank tap fittings once again for more options for you. You can used the strait or the swivel 90 degree unit. The inline filter can be mounted anywere. It can be mounted on the input or output side of the pump.
Mounting the single piece and 90 degree nozzle holder are the same. If your mounting in a silcone intake pipe Your going to put the washer on the nozzle push the threaded in through the hole you have drilled and screw it down. This can be done on rubber, silicon or metal. You can only screw it down so far the bonded rubber washer does the rest.
I'll get you a M3 out. I did not see it on your order.
1 x 3800 Progressive kit
- Nozzle Size: 5 Gph
- Controller: 2 Bar
- Tanks: No Thanks
With a Gen v blower and a 3.5 which would be the same as a 3.25 on a Gen 3 a M3 would be pretty useless.