[cobalt]

hello - your calculator suggests a 3.73 gph nozzle - my problem is that i have a supercharged cobalt and have drilled and tapped a hole on the bottom of the charger past the throttlebody plate - i spoke to someone several weeks ago and it was stated that u r coming out with a new nozzle - a thread in type from the outside - i don't need a 90 degree fitting with it unless i can't go directly into the brass check vave? - since i calculated 3.73 gph - how can i get one of your prototypes in a new progressive type system - i assume it should be a 3 gph nozzle - i beleive that is the size of your prototype (7000 rpm/18psi boost/2.0 liter - producing approximately 275 hp) - motor is very heavily modified w/ a lot of porting

please reply

ps - on the cobalt forum u r offering the kit with free shipping - is offer still good