I have got the basic system.
After buying it and doing some testing I found that the 01 Duramax Diesel has a 5volt MAP sensor. The small connector on the engine.
Pin c-8 a green wire is the one to ty into the controller.
I run 1.02 V at idle, 1.50V at 5 Psi. 3.7V at26Psi boost.
Looking forward to receiving the controller and installing.
One question I have is how to Tap the nozzle inlets inside a 3" hole?
Why diden't you make nozzles to install from the outside?
RMiller
