Devilsown Methanol Alcohol Water Injection - View Single Post - Continued Problems with Controller (SOLVED)

FYX193 · 09-11-2007

I have already double checked the controller, and originally the wires were not screwed down completely. I fixed that problem, but the controller still doesn't work properly.

I don't know if this is how it is supposed to work or not... If I set the start pot. to 2psi and the full pot. to 15psi (2 bar setup), the green (pump) LED is very dim, then it turns off and the yellow (full) LED turns on steady. The yellow (full) LED only turns off when I go into low boost or vac. Sometimes the same condition occurs and ends with the yellow (full) LED blinking.

I'll double check the pump wires to make sure they are properly connected; however, I am pretty sure they were still connected properly as the pump successfully primed the lines prior to connecting them to the solenoid.

09-11-2007	#3 (permalink)
FYX193 Water Injection Join Date: Jun 2007 Posts: 24	Re: Continued Problems with Controller I have already double checked the controller, and originally the wires were not screwed down completely. I fixed that problem, but the controller still doesn't work properly. I don't know if this is how it is supposed to work or not... If I set the start pot. to 2psi and the full pot. to 15psi (2 bar setup), the green (pump) LED is very dim, then it turns off and the yellow (full) LED turns on steady. The yellow (full) LED only turns off when I go into low boost or vac. Sometimes the same condition occurs and ends with the yellow (full) LED blinking. I'll double check the pump wires to make sure they are properly connected; however, I am pretty sure they were still connected properly as the pump successfully primed the lines prior to connecting them to the solenoid.