Devilsown Methanol Alcohol Water Injection - View Single Post

dvldoc · 05-21-2005

Around 100 psi is normally what it takes to support the 3.0 pulley on lightly modded cars. You might want to play with your turn on points. You don't physicaly have to touch the pump if use the controller. If you want less psi at WOT just turn the full point past how much boost you make. It sounds like your full is set to low. It doesn't take much for alcohol to overcome the heat of a 3.0 pulley.

So play with the start and full points first, then try turning up the pump a bit more if your seeing KR. If you get bogging then you'll know you went to far.

Hopefully you have a downpipe, because I wouldn't go down to a 3.0 without one.

05-21-2005	#2 (permalink)
dvldoc DevilsOwn Staff Join Date: Apr 2005 Posts: 2,164	Re: alky tuning help Around 100 psi is normally what it takes to support the 3.0 pulley on lightly modded cars. You might want to play with your turn on points. You don't physicaly have to touch the pump if use the controller. If you want less psi at WOT just turn the full point past how much boost you make. It sounds like your full is set to low. It doesn't take much for alcohol to overcome the heat of a 3.0 pulley. So play with the start and full points first, then try turning up the pump a bit more if your seeing KR. If you get bogging then you'll know you went to far. Hopefully you have a downpipe, because I wouldn't go down to a 3.0 without one.