Devilsown Methanol Alcohol Water Injection - View Single Post

Krister · 03-25-2008

Hey,

I started installing my Progressive kit yesterday.

I installed the pump and hose to my windshield washer tank and tested the pump. I hooked up the check valve and M7 nozzle and hooked power to the pump. There was no water spraying from the nozzle at all. Then I removed the check valve and tried again and it started working and I re-installed the check valve and it worked with it aswell. This just got me worried if the pump wouldnt be primed for some reason and the spraying wouldnt start. I have the pump installed maby few inches on top of the washer tank because there is no room for it below it.

Second question is if there is a problem installing the jet in the intercooler pipe around one feet or two before the TB when there is a pretty tight 90-degree bend before the TB. Will the methanol still distribute evenly?

I got the kit with the extra MAP-sensor because at the time I ordered it I was using the stock AFM. Now I have upgraded to a HKS VPC which has a Denso 3bar map sensor. Can I use this map sensor as a signal to the Progressive Controller?

Regards
Krister

03-25-2008	#1 (permalink)
Krister Water Injection Newb Join Date: Mar 2008 Posts: 1	Couple of questions Hey, I started installing my Progressive kit yesterday. I installed the pump and hose to my windshield washer tank and tested the pump. I hooked up the check valve and M7 nozzle and hooked power to the pump. There was no water spraying from the nozzle at all. Then I removed the check valve and tried again and it started working and I re-installed the check valve and it worked with it aswell. This just got me worried if the pump wouldnt be primed for some reason and the spraying wouldnt start. I have the pump installed maby few inches on top of the washer tank because there is no room for it below it. Second question is if there is a problem installing the jet in the intercooler pipe around one feet or two before the TB when there is a pretty tight 90-degree bend before the TB. Will the methanol still distribute evenly? I got the kit with the extra MAP-sensor because at the time I ordered it I was using the stock AFM. Now I have upgraded to a HKS VPC which has a Denso 3bar map sensor. Can I use this map sensor as a signal to the Progressive Controller? Regards Krister Last edited by Krister; 03-25-2008 at 05:00 AM.