 Re: rough idel
im not sure what you mean "use the smallest boost line that will fit over the nub" what nub what line, i follew the directions that were sent along with the kit, there was even a page in there pacific for the power stroke, including were the map sensor was an what wire to clip into, it works dont get me wrong there, its just it dosent seem to want to come on all the time, i tryed it last night set it to like 3 an it kicked on i think just under 20 psi, but like i said it dosent allways want to kick on, i will check the voltage later though im a lil behind for work, now what about the nozzels, cause if i put this thing to low it just comes on constant, an when im sitin there it takes a mater of seconds an the engine starts chokin is this not safe to use when idelin or am i sprayin to much in , an also just so were clear an i know i didnt screw up the part of the nozzel with the screen go's in the intake, i just wana make sure im doin this right
|