[JettaRed]

Here's pics of my install. 2004 Audi TT 225. The kit is a Universal Stage 2.

I mounted the pump under the airbox, but had to cut out a portion of the bottom of the box. The pump makes minimal contact with the panel filter. Using a cone filter is an alternative. (NOTE: Be sure to trim the screws on the inside of the wheel well so there is no contact with the tire!)

I ran the water feed line dirctly through the top of the washer tank using a 1/4" hole. (You need to remove the wheel well liner to access the tank.) I ran the black hose to the bottom of the tank. This was easier than mounting using the adapter that came with the kit.

I used a throttle body flange to mount the nozzle after the throttle body. The flange is available from Apex Tuning or USRT.

I mounted the controller in the little storage cubby under the ash tray. I drilled a 1/4" hole in the back of the tray to run the wires through the firewall.