 Help with install!
So I got a progressive kit from a TD.com forum member and the unit was supposedly working when he removed it from his car. I got it all wire up just to check everything out, I just ordered some quik fittings, new pump top w/female ends and some tubing from here 2 days ago. When I turn the key "on" the only light I get from the controller is the power light, no blinking "full" light to show status. Controller would not activate the pump during test runs and no lights showed other than the power light. Verified that my green wire is going to my map signal wire with a voltmeter. Key on/car off shows 1.58v, Key to accesory/car off shows .05v, car idling shows about .58v. I also verified these voltages at the map sensor to be sure and they are the same. My car is a 91 Dodge Spirit R/T with a 3bar map and computer. Kit came off of same kind of car. Any ideas? Did I get a bad controller? I thought the yellow light would blink if something was wrong with the controller? Will I need to buy a new controller or can this one be sent in a tested first? Thanks
|