Devilsown Methanol Alcohol Water Injection - View Single Post

MR T · 06-18-2008

I am looking to get the outside mount nozzles but i was wondering what would be needed to attach the inlet side to say a -4 an line . I want to use the braided line on the pressure side . I really dont trust the push in plastic line already blew one out on the dyno ( My Fault ) it was not fully locked in . Luckly no Fire ( running straight meth )

Also I am running a 2.0L 4g63 With GT42R @ 32 PSi car is making 625 HP 93 octane with straight meth Running a 550cc nozzle . I am still having a hard time getting my knock down . I think I just need to inject more meth .
The Calculator estimates about 14gph . Should i install 2 nozzles ore just one? I think 2 is my best option . Then I can swap out sizes easier .

My goal is around 700WHP on this set-up @ around 38-40 Psi can it be done ? Any recomendations?

06-18-2008	#1 (permalink)
MR T Water Injection Newb Join Date: May 2008 Posts: 4	Nozzle Questions I am looking to get the outside mount nozzles but i was wondering what would be needed to attach the inlet side to say a -4 an line . I want to use the braided line on the pressure side . I really dont trust the push in plastic line already blew one out on the dyno ( My Fault ) it was not fully locked in . Luckly no Fire ( running straight meth ) Also I am running a 2.0L 4g63 With GT42R @ 32 PSi car is making 625 HP 93 octane with straight meth Running a 550cc nozzle . I am still having a hard time getting my knock down . I think I just need to inject more meth . The Calculator estimates about 14gph . Should i install 2 nozzles ore just one? I think 2 is my best option . Then I can swap out sizes easier . My goal is around 700WHP on this set-up @ around 38-40 Psi can it be done ? Any recomendations?