Devilsown Methanol Alcohol Water Injection - View Single Post

Wideopentuning · 07-01-2008

Hey guys. I finally got to do an install on my own vehicle. I decided trunk mount would work the best for me. I used riv-nuts to make the tank and bump very simple to take in and out but very solid. I still need to wire up my float switch to my low washer fluid light in the cluster. I also have not chosen where my 3 bar controller will live permanently so for now its just in the glove box. I am using a Klavico 3.5 bar map sensor and a 5 gph nozzle. I could probably utilize a 7 gph when I run at my high boost setting of 20 psi. I daily drive at 11 psi. I will have dyno numbers with and without the kit active soon. Here are some pics of the car and the install.

07-01-2008	#1 (permalink)
Wideopentuning Approved Dealer Join Date: Aug 2006 Posts: 66	Install on my 1997 Gti Vr6 Turbo Hey guys. I finally got to do an install on my own vehicle. I decided trunk mount would work the best for me. I used riv-nuts to make the tank and bump very simple to take in and out but very solid. I still need to wire up my float switch to my low washer fluid light in the cluster. I also have not chosen where my 3 bar controller will live permanently so for now its just in the glove box. I am using a Klavico 3.5 bar map sensor and a 5 gph nozzle. I could probably utilize a 7 gph when I run at my high boost setting of 20 psi. I daily drive at 11 psi. I will have dyno numbers with and without the kit active soon. Here are some pics of the car and the install.