[msmx5]

My Devils Own stage II progressive water meth injection kit Mazdaspeed mx5 how to

I put orange tape on the water/meth injection tubing to make it easier to see in the picture.

install pictures for a Mazdaspeed mx5
http://www.mazda-speed.com/gallery/my-Devils-own-stage-2-water-meth-injection-kit-mazdaspeed-mx5-how-to

more pictures
Mazda-Speed.com :: my devils own stage 2 water meth injection kit

[Dust]

What are pics 10 and 11? I can't make them out? Where did you mount your nozzle?

[msmx5]

Originally Posted by Dust What are pics 10 and 11? I can't make them out? Where did you mount your nozzle?

I edited pictures 10 & 11 in Mazda-Speed.com :: my devils own stage 2 water meth injection kit

The spray nozzle is installed in the intercooler outlet pipe about 1 foot & 2 inches below the throttle body intake air temperature (IAT) sensor. I installed the injector as far as my fingers could reach into the pipe. these pictures will help

see the pump in the picture?
see the throttle body inlet pipe with the IAT sensor on the left side of it in the picture?



This is a closer picture of the pump. See the water/meth tubing coming out of the pump on the right side of the pump in the picture?



Ok this is an even closer picture showing the water/meth tubing coming out of the right side of the pump. See the water/meth tubing leading down to the injector that is installed in the intercooler outlet pipe



Here is a picture taken from under the car, under the passenger side wheel well, of the nozzle in the intercooler outlet pipe.

[Dust]

The orange you highlighted goes to the tank then I guess?

[msmx5]

Originally Posted by Dust The orange you highlighted goes to the tank then I guess?

Yes it does go to the tank. I wrapped orange tape around the water/meth injection tubing so it would make it more visible in some of the pictures that I took of it. Here is a different picture

[Dust]

No worries, I saw the tubing running across te engine bay and didnt see a nozzle. Just wanting to check.

[sharkey]

i like the controller install, looks almost factory

[boost geek]

That flush mount controller install looks awesome!

[gsrtype1]

Nice! im gonna install a stage 1 kit on my mazdaspeed3 this weekend

[hardmack]

No worries of system lag there!

Mine is in similar style setup on my srt...

Longish run from windshield wiper bottle on the top of my intercooler and then to the pump (front pass fender to front driver fender) then through frame rail to cold side intercooler pipe and into TB