Registration is free.
Join us today.
2/3 bar controller needs to see how many volts to turn on?
This is a discussion on "2/3 bar controller needs to see how many volts to turn on?" within the Technical Questions forums. This forum, and the thread "2/3 bar controller needs to see how many volts to turn on? "are both part of the General Performance category;
Devilsown Methanol Alcohol Water Injection
> General Performance
> Technical Questions 
2/3 bar controller needs to see how many volts to turn on?
 |
| | LinkBack | Thread Tools |
01-18-2007
| #1 (permalink) |
| Water Injection Newb Year: 2004 Make: Dodge Model: SRT-4 Join Date: Sep 2006
Posts: 8
|  2/3 bar controller needs to see how many volts to turn on?
How many volts does the controller need to turn on the pump, and to turn the pump on in full mode? I'm getting about 4.0-4.2 volts at 20 lbs of boost. Should this kick in the pump to run into full mode with the max boost dial on the controller set at 12 psi.
|
|  |
|
01-20-2007
| #4 (permalink) |
| Water Injection Newb Year: 2004 Make: Dodge Model: SRT-4 Join Date: Sep 2006
Posts: 8
| Re: 2/3 bar controller needs to see how many volts to turn on?
Ok thank you very much for that chart.. which just conferms there is nothing wrong with my map sensor's output voltage. However my controller will still not go into full mode anytime there is fluid in the tank.
|
|
| |
