Controller Conversion For 3 Bar Map Sensor Use

This is a discussion on "Controller Conversion For 3 Bar Map Sensor Use" within the Technical Questions forums. This forum, and the thread "Controller Conversion For 3 Bar Map Sensor Use "are both part of the General Performance category;

05-20-2005

#1 (permalink)

dvldoc

DevilsOwn Staff

Join Date: Apr 2005

Posts: 2,058

Controller Conversion For 3 Bar Map Sensor Use

When using with a 3 bar MAP use this table.

Attached Images

	3barv2bar_map.gif (26.9 KB, 1432 views)
	high_3bar_set_up.jpg (26.8 KB, 111 views)
	alc.jpg (28.0 KB, 51 views)
	2_and_3_bar_small.jpg (12.9 KB, 71 views)
	3_bar.jpg (68.6 KB, 54 views)

« Progressive Controllers Inside Take A Peek | Preliminary results of my tuning/experience with alky »

Thread Tools
Show Printable Version Email this Page

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using MAF sensor for progressive injection	sizemoremk	Technical Questions	3	07-23-2005 09:53 AM
Using a 3 bar map sensor for less than 10 psi boost levels?? Is it possible?	eunos93	Technical Questions	1	07-06-2005 03:54 PM

All times are GMT -5. The time now is 07:22 AM.