[RotaryXperiment7]

i was wondering if i could use a fuel cell for my setup, i was gonna run on the washer fluid resovoir but it might be to small.

can i use this one?
eBay Motors: Jaz 1 gallon NOS Fuel Cell (item 230250943621 end time May-15-08 11:41:40 PDT)


also if i get that one how can i run the lines?

[dvldoc]

There are better options for a trunk mounted set up if you want the cell type of tank. I'll PM you some stuff.

[RotaryXperiment7]

i kinda like the professional look of the one i posted, but running SS lines all the way across the car will cost me too much haha.

[dvldoc]

The tanks I sent you are the only other ones I know of that are different than what we have.

[RotaryXperiment7]

is there a way to convert the AN fittings to use the nylon tubing on a fuel cell?

[dvldoc]

Originally Posted by RotaryXperiment7

is there a way to convert the AN fittings to use the nylon tubing on a fuel cell?

You can replace them with the Quick connect fittings, Those are probably 3/8"NPT at the end. Just unscrew them and put in our fitting. You can use a 3/8"NPT plug in the other side that is not going to be used.

[RotaryXperiment7]

o good idea thanx, wat bout the one that woukd have gone to washer fluid resovoir that uses a washer. how do i use that fitting

[dvldoc]

If your going to get rid of that you can buy one of our plugs to cap it off. I think that's what your asking.

[RotaryXperiment7]

ok getting confusing now haha. looks like i may need a low level sensor, a return fitting, and a supply fitting to the pump.
which supply fitting do i use

[dvldoc]

I don't know why you would need a return line there is nothing to return, I would cap that off, You have to drill a hole for the level sensor it has it's own sealing fitting. Just check to see if the AN fittings have a 1/4npt thread or a 3/8npt thread if you do get that then you'll know what to get, I can't tell from a pic what size there are.