Registration is free.
Join us today.
Meth Injection and Fuel Cut Rev Limiters?
This is a discussion on "Meth Injection and Fuel Cut Rev Limiters?" within the Technical Questions forums. This forum, and the thread "Meth Injection and Fuel Cut Rev Limiters? "are both part of the General Performance category;
Devilsown Methanol Alcohol Water Injection
> General Performance
> Technical Questions 
Meth Injection and Fuel Cut Rev Limiters?
 |
| | LinkBack | Thread Tools |
06-10-2008
| #1 (permalink) |
| Water Injection Newb Year: 1999 Make: Mitshubishi Model: Eclipse GSX Join Date: May 2008
Posts: 4
|  Meth Injection and Fuel Cut Rev Limiters? I have been thinking about this possable issue that might come up when using fuel cut as you rev limiter . I my self run a Aem Ems so I can only cut ignition to limit revs but lets say i had it set to fuel cut . Once i reach my desired rpm the main injectors will cut fuel ( which will also most likely give me zero boost ) But is there any chance it could run lean long enough due to the fact that it is still injecting meth ? I dont think it is possable because the boost will be very low if not any at all and the system should shut off at that point . I would just like to here other opinions on this . |
|  |
|
06-10-2008
| #2 (permalink) |
| DevilsOwn Staff  Join Date: Apr 2005
Posts: 1,884
| Re: Meth Injection and Fuel Cut Rev Limiters? Hook the system to the TPS sensor or MAF sensor or lower the rev limiter or raise the fuel cut off point above the limiters range. I don't know if your software can do that or not.
__________________ Deploying to Iraq Aug 2008  |
|
| |
