[mjeffries]

I have the DevilsOwn base injection kit, it has been installed for a few months and has been (as far as I know!) working fine. One thing that does worry me is that the outside mount nozzle that came with the kit BARELY threads into my intake pipe.

I haven't had any problems with the nozzle coming out but I still feel very uncomfortable with the way its mounted. I can put my hand on it and rotate it VERY easily if I wanted to. I am considering ordering an Inside Mount nozzle and using that instead.

Do you see any reason for me to not use the inside mount nozzle?

[dvldoc]

No there is no reason not to use it. But you don't need it, those mount inside and outside just like the other nozzles do. Just take it from the outside and slip the filtered end back up through the hole and tighten it down. Oh yeah pop off the o-ring.

If the pipe was not tapped right or is very thin you will get a loose fit, Since it's a NPT fitting you have to tap a little at a time or it will be loose.

[mjeffries]

I decided to go with one of your "inside mount" nozzles instead of re-using the outside mount nozzle. I ordered it a few hours ago and now I have a concern.

Am I going to need one of those metal/rubber washers to install this inside mount nozzle?

[Dust]

The outside mount nozzle can also be used as an inside mount nozzle. You knew that right?

[mjeffries]

Originally Posted by dvldoc

. . . you don't need it, those mount inside and outside just like the other nozzles do. . . . .

Originally Posted by Dust

The outside mount nozzle can also be used as an inside mount nozzle. You knew that right?

I'm going with the inside mount.