[Stez]

we connected Progressive Controller and all the system according to the manual instaction. but when we applied the power to controller - all 3 leds lights together and always, and do not turn off... we read the manual to the leds indications but there was no such combination and understanding what does that mean :(

can anybody tell - may be we did something wrong??? and what does that mean when all three leds is on??

Thanks

[dvldoc]

It could be one of a few things remember the controller only knows voltage.

You have the green wire (5v output) hooked to the 5v input of the sensor) be sure to check the sensors output with a volt meter it should be around 1.8 volts at idle with a 2 bar. Not all cars are the same most GM cars it is the center wire but other brands are totaly different.

If the third led is not flashing it is not a fault. This is a very rare instance open the case of the controller and check to make sure the grey wire is were it is supposed to be and the green is were it is supposed to be on the terminal, it's labeled. Hardley ever happens but you assemblee a few thousands of these and it can happen every now and then.

Now if it just comes on intermetent like every now and then then this is the controller hunting for a signal which means the map sensor connection is not solid.

Let us know what you find out.

[Stez]

i opened the case, wow, all wires is mixed and wrong according to the specified, check the pic below

[Stez]

as you can see. according the signs: +12 ignition is GREY, To pump - GREEN, the only wright the ground is black, MAP is blut and red is +5v signal .....

and what should i do now??? connectr controller according to this significations or...? and will it work now after connection according to instruction wich is different of this...

Let me know please...

[dvldoc]

Looks like were going to have to have a talk with controller builder about this unit. Connect the wires back to the specs of the controller. If you have any issues with it send it back and will get you a new one asap.

[Stez]

we change the wires back accoring to the signs but no effect... looks like its down :(

[dvldoc]

Well the fact it was not connected right probably screwed it up. PM rocket468 with your address and we'll get you a new unit out ASAP.

[Stez]

ahmm, sorry should i pm him here on the forum?

or may be you can give him my address:
Igor Stetsyuk, Ukraine, Kiev 02156, Bratislavskaya St. 10 - 7

[Stez]

any progress on this case?

[pacemkr86]

bump