[larry arizona]

Was thinking of adding a W/M inj kit to a otherwise stock Honda Turbocharged Personal water craft. The stock ECM can't be decoded easily to add timing, but it is very easy to increase boost 4 to 5 PSI with a manual boost controller. The Honda has a intercooler but it becomes a bit taxed at higher boost levels. Normally with increased boost over stock, the use of 50-50 mix of 93 and race gas is required to prevent the ECM for putting in retard mode.

Is W/M going to work in this application?

[dvldoc]

Yes it will work on this application, So do inject into the exhaust rather the intake but you will get better effect injecting into the intake.

[larry arizona]

I am sorry but your response was a bit confusing. Are you saying that installing the injection prior to the turbo is better than injecting after the turbo? I assume both will work but intake is better than exhaust?

Can you recommend a kit for this application. 1235CC inline 4 turbocharged.

[pacemkr86]

Yes this system will work perfect for your application..

Id love to see some photos of this PWC and engine compartment

[dvldoc]

Originally Posted by larry arizona

I am sorry but your response was a bit confusing. Are you saying that installing the injection prior to the turbo is better than injecting after the turbo? I assume both will work but intake is better than exhaust?

Can you recommend a kit for this application. 1235CC inline 4 turbocharged.

If you look up MSD water injection kit it is use in the exhaust kinda a odd way to do it but that's how theres is set up. I would not run it that way.

Since your using this on a water craft I would use the Stage 1 kit with a DO1 nozzle.